A Step-by-step Guide for Installing Your Water Tank

Installing a water tank can be a daunting task. Luckily, there are guides on how to easily install a water tank.

This post will help you from preparing the ground for installation and connect the tank to your home’s plumbing system.

Consider The Following Before Starting

Ensure you have all the necessary supplies. Here’s a list of what you’ll need:

– Water tank

– Level

– Tape measure

– Pencil

– Shovel

– Wheelbarrow

– Cement

– Sand

– Gravel

– Pipe wrench

– Hacksaw

– Teflon tape

– PVC cement

– Primer

– Solvent cement

When you have the supplies ready, it’s time to start planning the installation.

Excavate the Hole

This is where you’ll need some help, ask a friend or family member to give you a hand.

Measure the size of the hole, then dig down to that depth. The sides should be straight, so use a shovel or spade to get the job done.

If the soil is hard, you can use a pickaxe to break it up.

Level the Hole

Before digging your hole for the water tank, it’s essential to ensure its level. You can use a spirit or builder’s level to do this.

Once you’ve marked out the hole’s location, use a shovel to dig it out. When you’re finished, use a rake to level the surface. Once the spot is ground, it’s time to start assembling the water tank.

Instal the Base

Before installing your water tank, you need to make sure you have a solid base to work with. This could be a concrete slab, brickwork, or timber frame.

When installing your water tank on a concrete slab, you’ll need to ensure the surface is level and free from any bumps or lumps.

Brickwork and timber frames should also be levelled before you start the installation.

Once your base is ready, simply place the tank on top and gently lower it into position. Make sure the tank sits squarely on the ground, then use the supplied screws to secure it.

Instal the Tank

Now it’s time to instal the tank. After that, it gets tricky; here are some quick guides.

1. Find the perfect spot for your tank and mark the outline with some spray paint.

2. Dig a hole that’s big enough to fit the tank, and make sure it’s level before you start filling it in.

3. Instal the tank using the bolts and washers that came with it, and tighten them up using a wrench.

4. Before proceeding, connect the inlet and outlet hoses to the corresponding ports on the tank and ensure that they are tight.

5. Connect the power supply to the pump, and make sure everything is turned off before you do that!

6. Turn on the pump and let it run for a few minutes to check for leaks.

7. Fill up your tank and enjoy fresh, clean water!

Instal the Pre-Cast Concrete Lid

Next, you’ll want to instal the pre-cast concrete lid. Again, this is a straightforward process; you only need a level and a drill.

First, ensure the concrete lid is in the correct position and flush with the ground. Next, create pilot holes in each corner of the lid by using a drill. Once the holes are drilled, insert the provided screws and use a level to ensure everything is straight.

Backfill Around the Tank

The next step is to backfill the tank. This will help stabilise it and keep it in place.

Use a shovel to fill the area around the tank with soil, making sure to pack it down well. You can also use a compactor to ensure the soil is nice and tight. Continue filling the area until it’s about level with the ground around it.

Conclusion

A water tank is part of our modern living; they provide a constant and reliable source of water that can be used for anything from drinking and cooking to washing and watering the garden.

However, many people are put off by installing a water tank because they think it will be too tricky or unsure where to start.

This guide will make installing a water tank a little less daunting, and you can enjoy all the benefits that a water tank offers.

Leave a Reply

Your email address will not be published.

error: Content is protected !!